Load image into Gallery viewer, YS-D3 Lightning Strobe Mark II

YS-D3 Lightning Strobe Mark II

Name: YS-D3 Lightning Strobe Mark II
Brand: Sea & Sea
SKU: SS-03123
Price: 1,789.00 AUD
Availability: InStock

Sea & Sea

$1,789.00

Tax included.

Quantity

Description

High Performance Strobe

Newly designed circuitry and light-emitting unit produces powerful guide number of 33. In addition, a high precision aspherical optical troidal lens has been fitted over the two flash tubes to disperse an even light from the center to the edge. The strobe`s beam angle will increase to 110°by attaching the standard accessories Diffuser. When the optional Dome diffuser is attached, beam angle will increase to as wide as 150(TBD)

In order to avoid misunderstanding, the YS-D3 guide number (GN) and the beam angle are based on measurements taken on land (not underwater)

Some competitors will often state a GN measured on land and the beam angle in water, for example a GN 33 and beam angle of 110 degrees. However, this GN 33 value is based on a beam angle of 60~70 degrees. The beam angle may be expanded in water by a dome effect, however the GN in water is significantly lower than the value measured on land.

Note: A land-based strobe that uses the same four AA batteries as the YS-D3 may provide a notation that the GN is 60, but these measurements are taken under the condition that the focal length is equivalent to 200 mm (= beam angle 12 °). When the beam angle becomes narrower, the brightness of the illuminated area increases due to the light-collecting effect.

Superior consecutive firing capability to capture those critical moments.

The YS-D3 utilizes larger capacity condensers compared with those used on competing strobes. In addition, the D3 is also equipped with a newly designed charging circuit. As a result, the YS-D3 will fire at GN16 continuously without any interval time. Even when the strobe is fired at GN22, the strobe will fire again within a mere 0.8 seconds.

When the YS-D3 is fired at Guide Number over 22, a two-stage ready-to-fire signals will be issued. For instance, after the strobe fires at full power of GN33, the strobe will inform you both visually and audibly when the condenser is charged to fire at GN22. Then, when the condenser is charged enough to fire at GN33, another different signal will be issued. This design allows you to release more shutters in scenes where you want to shoot as many pictures as possible, maximizing shooting intervals between scenes.

Target light with increased power

incorporating a uniquely designed aluminum heat diffuser, the target light is now powerful enough to be used as a dive light.（About 4 times brighter than YS-D2）

Various accessories available for all underwater imaging experiences (sold separately)

・Dome diffuser (optional accessory)

Increases beam angle to 170°×150° Essential accessory when fisheye lens is used, or soft light is required.

+ Guide number will drop to -1.5EV when it is fitted.

・Snoot (optional accessory)

A strobe adaptor which narrows the beam angle to be directed at a target point. Diameter of the opening 25mm. Designed with internal prism which aligns target light`s light axis and strobe`s light axis to the center.

・Slave prism (optional accessory)

Optical guiding device to fire the strobe when a fiber-optic cable is not used. This device is for manual use only. The device is effective if multiple strobes are used in a fixed position. However, the flash may not fire depending on the position of where multiple flashes are occurring in relation to that of the master flash.

Excellent visibility

Backlight panel that is effective when shooting in dark environments The indicator color on the back of the YS-D3 changes each time the position of the mode switch is changed. Blue (in DS-TTLII mode), light blue (in slave TTL mode), orange (in manual mode with pre-flash), and green (in manual mode without pre-flash) The positioning of the operation system is obvious during night diving.

* The color in DS-TTLII mode has been changed from the YS-D2 to match the color with the optical converter.

Connection method with arm that can be selected according to preference

YS-D3 comes with a straight type ball base.

Optional YS base and new Diagonal ball base can be installed depending on the application.

YS base (common to YS-D1 / D2 / D3)

Traditional YS base. Easy vertical swing.

Diagonal ball base (only for YS-D3)

A ball base inclined at 35 ° compared to the straight type. This makes it easier to lower the strobe backwards, making it suitable for shooting when using a dome port. Also, when a Synchro Cord N is installed, interference between the cord and the ball clamp is minimized.

[Guide Number (ISO 100/m) (land)] : 33, 28 (with Diffuser attached)

[Beam Angle] : 105°x80° (without Diffuser), 110°x100°(with Diffuser)

[Batteries] : 4xAA A: 6V Ni-MH: 4.8V

[Number of Flashes *1] : A: 140 Ni-MH: 220

[Recycle time (full) *2] : A: 3.5 sec. Ni-MH: 1.7 sec.

[Color temperature] : 5800K

[Color temperature w/diffuser] : 5500K

[Depth rating] : 100m / 330ft

[Dimensions (WxHxD)] : 92x111x147mm / 3.6 x 4.4 x 5.8 inches (excluding ball base)

[Weight] : 610g / 21.5oz (w/o batteries) (excluding ball base)

[Underwater weight] : Approx.-20g / -0.7oz (incl. batteries ball base)

[Others]

Exposure control: DS-TTL II, Slave TTL, Light level control dial (GN): 1 / 1.4 / 2 / 2.8 /4 / 5.6 /8 / 11 / 16 / 22 / 33 (11 steps)

DS-TTL II function

Slave function

Auto power OFF function 30min

Sync cord: 5-pin Sync cord/N, Fiber-Optic Cable

Over-pressure relief valve

LED target light (output is adjustable in 2 steps)

Audible charge signal

*1 Number of flashes and recycle time depends on the battery brand, temperature and frequency of use.

*2 Number of flashes and recycle time of Ni-MH batteries were tested on 2500 mAh batteries.

Delivery & Shipping

Shipping

Perth Scuba will ship the next business day to anywhere in Australia. Where a product is not in stock, the purchaser will be notified on the next business day of an approximate delivery date.

Generally orders will be sent by Australia Post or Couriers Please and it is recommended that you purchase additional insurance for your items as once they are dispatched they can be tracked to your doorstep.

Perth Scuba shipping is subject our carriers shipping conditions. If you prefer to use an alternate shipping company – please notify us at the time of placing your order (select in-store pick-up).

Shipping Options

Australia Post – standard 3-10 days within Australia

Australia Express Post – A tracking number will be provided on dispatch by email. Guaranteed next day delivery after dispatch only within the Express Post network. For example Perth metro area = next business day delivery, other metro area = 2 – 3 business days, outside metro area 2 – 5 business days

DHL Express – A tracking number will be provided on dispatch

In-Store Pick-up – Select this option to pay in full online and then collect from our store located at Unit 4/180 Bannister Road, Canning Vale WA 6155. We’re open 7 days a week from 9:00am – 5:00pm except Public Holidays. Perth Scuba will advise by email when your order is ready for collection

Perth Scuba accepts no liability for consequential loss or damage where postage selected by the customer does not include insurance or tracking.

Order Acceptance / Confirmation

Once we receive your order, we’ll provide you with an email order confirmation. Your receipt of an order confirmation, however, does not signify Perth Scuba’s acceptance of your order, nor does it constitute confirmation of our offer to sell; we are simply confirming that we received your order. Perth Scuba reserves the right at any time after receiving your order to accept or decline your order for any reason. If Perth Scuba cancels an order after you have already been billed, Perth Scuba will refund the billed amount.

Returns Policy

Refund Policy (General)

Perth Scuba will not issue a refund if you simply change your mind about something you bought, we will however, offer you a store credit to the value of the purchase price. The item must be returned in an as new sale-able condition along with the original purchase receipt.
Refunds will be offered in instances where it is agreed that a new item is faulty and cannot be repaired and at the discretion of Perth Scuba management. Every effort will be made to ensure any merchandise required to be returned to a manufacturer as fast as possible, so it can be returned to the original purchaser in the shortest possible time-frame.

Returns (online purchases)

It is your responsibility to notify Perth Scuba as soon as possible if the item purchased is not suitable or if it has been damaged in transit.
Perth Scuba will take all possible care in packing to ensure minimal movement within the package during shipping.
Refunds will only be processed upon receipt of the items in an as new saleable condition. Returns are to be sent at the cost of the returning party unless agreed by Perth Scuba prior to return item being sent. Perth Scuba reserves the right to reduce the amount refunded for damaged packaging where it left the store in new condition.